---
title: System Setup: Scalae Control
slug: system-setup-scalae-control
docTags: 
createdAt: 2024-02-10T11:29:42.811Z
---

## Lead In

This section will step the systems integrator through what is required to set up each unit.

## Setup Requirements

Two SCALAE-CONTROL units are needed, 1 in the transmission role, and the 2nd in the receive role.

**Transmission Unit**:  the actuation signal from the "CONTROLLER" and transmits to the receiving unit. 

**Receive Unit**: Receives the signal and actuates the output.

## Transmission Recieve Unit Pairing

### Step 1: Transmission Unit

Work through the following steps to set up the transmission unit.

- Of the two units, select one and install the transmission RF Module
- Locate the "Settings" dip switch bank and move the TX switch into the "ON" position unit
- Locate the "Address" dip switch bank, and set the address for "101010".

### Step 2: Receive Unit

Work through the following steps to set up the receiving unit.

- Of the two units, select one and install the transmission RF Module
- Locate the "Settings" dip switch bank and move the RX switch into the "ON" position unit
- Locate the "Address" dip switch bank, and set the address for "101010".

## Lead Out

In the next sections, we will discuss power and relay connections.