How To Use Our Product Lines
How To Use . . . Control
System Setup: Scalae Control
4min
lead in this section will step the systems integrator through what is required to set up each unit setup requirements two scalae control units are needed, 1 in the transmission role, and the 2nd in the receive role transmission unit the actuation signal from the "controller" and transmits to the receiving unit receive unit receives the signal and actuates the output transmission recieve unit pairing step 1 transmission unit work through the following steps to set up the transmission unit of the two units, select one and install the transmission rf module locate the "settings" dip switch bank and move the tx switch into the "on" position unit locate the "address" dip switch bank, and set the address for "101010" step 2 receive unit work through the following steps to set up the receiving unit of the two units, select one and install the transmission rf module locate the "settings" dip switch bank and move the rx switch into the "on" position unit locate the "address" dip switch bank, and set the address for "101010" lead out in the next sections, we will discuss power and relay connections